Driveshaft Removal - SaabCentral Forums
网页2009年12月5日 — to remove the whole drive shaft , make sure its pushed right into the gearbox , then give it a decent pull , if it doesnt come out push it back in , then pull on it again, if there still is trouble , get a tyre lever , or some thing similair , and lever it out from between the cv joint and the gearbox.
CV Axle Replacment - Saab 9-3 (2003-2012) - SaabWorld
网页2020年10月1日 — Remove the outer spline from the hub and with an "jerking" motion pull on the axle shaft to dislodge the inner spline. Make sure the shaft seal remains in place.
XWD rear CV boot replacement - SaabCentral Forums
网页2014年2月24日 — I used a rag to limit the amount of metal shaving that got near the bearings. This picture shows the retaining clip that needs to be removed in order to remove the bearings. After cleaning everything in a parts washer, I slid the smaller ring onto the shaft, followed by the new boot and then re-installed the bearings.
Removal of Driveshaft | SaabCentral Forums
网页2007年2月10日 — Im curerntly in the process of removing the driveshaft, but I cant seem to do it! At first I tryed removing the tourqe bits and the plate thinking thats...
XWD 9-3 Drive Shaft / Prop Shaft (3-Piece) Transfer Case to Rear …
网页XWD 9-3 Drive Shaft / Prop Shaft (3-Piece) Transfer Case to Rear Diff. · It is highly recommended to always use 3 new stretch bolts (no5 in diagram, PN 13324897, 3x) when replacing the XWD prop shaft. · w/ XWD. · There is an extended wait time on this item. Current availability is approximately 8 weeks.
Change SAAB 9-3 CV Joint yourself – manuals and video tutorials
网页2019年6月10日 — Illustrated step-by-step manuals and video tutorials on replacing SAAB 9-3 CV Joint will tell you how to carry out DIY replacement of parts and maintenance of your car quickly and cheaply.
change inner cv boots - Saabscene
网页2003年8月23日 — To remove, you need a slide-hammer, according to Saab. Take two large hose clips and put them round the flange, then tighten them around the shaft of the slide-hammer to fix the shaft to the flange.
Drive shaft removal - Saab Link Forums
网页2010年5月30日 — I tried yanking on the passenger side half shaft for over and hour to no avail. Finally found out why. There is a nifty snap ring sitting on the inside lip of the end of the intermediate shaft that has to be removed: http://www.saablink.net/forum/car-problems-ng900-old-9-3-only/42735.htm.
Drive Shaft Replacement | Saabscene Saab Forum - Saab …
网页2007年7月10日 — Drive Shaft Replacement. Hey there, Need some help with a part number for the drive shaft. The car's probably doing close to 400Nm of torque and as such, the drive shafts not too happy as of late. Opened up the baby and found that one of the tripod bearings was worn through and through.
To remove, right-hand – 9-3 2000 | SAAB Workshop Information …
网页1. Remove the hub cap and undo the hub centre nut (leave the nut on). 2. Lift the car and remove the wheel. 3. Remove the hub centre nut. 4. Undo the nut on the ball joint bolt. 5. Remove the ball joint bolt with 89 96 696 Puller. 6. Unscrew the nut on the anti-roll bar. Keep the washer and rubber bush safe. Lower the link arm. 7.