The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

Yes, we can transfer the data like indicated but not sure this is the most optimal option. Can you please explain what you are trying to do? On the camera side what serializer are you going to use?

I am calculating the power consumption of all components on my circuit for thermal simulation. The circuit is the same as typical application circuit in the datasheet below and all FETs are ...

The value of Rfilter is 100 ohms, 0.1% tolerance, for each resistor <- while this value is 10x the recommended value, I suspect it does not have a great impact on our operation, your feedback would be ...

I am asking this for our customer. F280013x is in I2C target. In some cases, F280013x may have sent a byte by writing the byte onto I2CDXR but gets STOP from the controller, so the byte is in I2CXSR ...

Can the IN+ and IN- of the INA180-Q1 current sensing operational amplifier meet the 5B pulse requirements? (Note: The front-end circuit will have a TVS tube, clamp voltage: 38.9V) ...

Hi，I am using the bq40z50-r2 chip for 2S1P battery packs. I now want the battery pack to be able to actively turn on the discharge MOS when plugged into the power supply device, and then automatically ...

I am working towards answering your question, but the lab work required will take me a bit of time. I will have an answer for you by the end of the week. There is no ripple specification that has been ...

We used AWR2243P to realize chip cascade before, but now we can only buy AWR2243 from TI Mall and authorized distributors. It is clearly stated on TI official website and the product description of ...

I'm currently trying out spi_ex4_external_loopback_fifo_interrupt.c and wanted to know how I can use the slave to send a response AFTER the master's request. In the attached image, the slave (blue) ...

We have found LM5064 for the solution. As per the datasheet page#21 to maintain accuracy, the sense resistor voltage should not be less than 3 mV. But our calculated Vsense voltage comes near 1.5mV.

I encountered a problem when debugging the HRPWM. The EPWMCLK is 100MHz，I think the MEP_ScaleFactor should be 65 or 66 cause the MEP step size is 150ps. But when I use the SFO function, the ...