PFC驱动部分的，EPWM1-A和EPWM1-B起的什么作用？我看在程序里没有设置它的占空比？ 在Lab4中关于如下代码几个变量的理解 ...

The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

I am currently trying to use the 280039C to build the functionality of CAN FD. My idea is to use RF0N (Rx FIFO 0 New Message) to trigger the interrupt, Read RAM FIFO data in interrupt 1. The problem ...

Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask ...

Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask ...

Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask ...

I am generating a sinusoidal signal of amplitude 5 and frequency 200 Hz using sine wave block of simulink in sample based mode and connecting the output to DAC block of embedded coder support package ...

Texas Instruments (TI) Bluetooth® support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search Bluetooth® IC content or ...

Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC ...

We are building the Ti Yocto Linux but everytime it gives an error in the following package, gdk-pixbuf_2.42.10. This is the command that we use for the setup: ./oe ...

A few questions/suggestions I have: 1) How did you set the BPF_A2_MSB and _LSB values? More specifically, how did you set/calculate the _LSB=0xFF? This should still work, but you can also refer to the ...

To unseal the device, use the ManufacturerAccess() 0x00 command and the UNSEAL (0x0031) sub-class and your valid SHA-1 key that has been programmed into the device prior to SEALing the device (0x0030) ...