DIY Mercruiser Alpha One Gen 1 Lower Unit Removal- Step 1
网页2020年8月23日 — DIY Mercruiser Alpha One Gen 1 Lower Unit Removal- Step 1. There are many parts of your outdrive, like the bellows, shift cable, impeller and water pump housing, that...
Mercury Mercruiser Alpha One Lower Unit Removal - YouTube
网页I demonstrate how to remove the lower unit from a Mercruiser Alpha One drive.
How do i separate or remove my Alpha One lower unit - YouTube
网页Need Tech service help see http://www.sterndrive.info/alpha-one/how_to_videos.htmlT.C. Electronics/Marine have exploded view drawings and repair videos for m...
Alpha One Gen One lower unit rebuild - iboats Boating Forums
网页2014年3月4日 — Re: Alpha One Gen One lower unit rebuild Chris in the lower, on a standard rotation, the forward gear shims are located behind forward gears bearing race. This moves forward gear forward and back as needed. And the reverse gear shim is located between the carrier and a lip in the lower unit that carrier sits …
Rebuilding a Mercruiser Alpha One gear housing - Sterndrives.Com
网页Note: If you have had a failure in the lower drive, you must also disassemble, clean and inspect the upper drive. Bits of metal, metal shavings, rust or water will travel through the shared oil passage from one housing to the other.
Difficulty installing Alpha 1 lower unit - iboats Boating Forums
网页2013年12月18日 — The sterndrive is a 1988 Alpha 1. This is a restoration project. I pulled the lower for water pump replacement. I pulled the upper to grease the u-joints and replace the gaskets and water passage O-ring. I chose to install the upper first rather than mating the upper and lower first.
Alpha 1 lower unit removal???? - IFish Fishing Forum
网页2009年11月13日 — Try and download a copy of an Alpha 1 service manual. After you get the lower unit off, take the water impeller off and bring the whole assembly with you to get the replacement one. There are a a couple versions (gen I, II, ect...).
Alpha One & Gen 2 Outdrive Parts *Drawings *Videos - sterndrive
网页Mercruiser Alpha one and Gen 2 outdrive parts. Lower unit exploded view drawings and GLM Marine aftermarket catalog.
Alpha 1 Gen 2 Lower unit removal - iboats Boating Forums
网页2014年3月11日 — Hi Im trying to separate the lower unit from the upper unit on my Alpha 1 Gen 2 Outdrive, S/N OL 634881 in order to renew the impeller. Ihave removed all 6 bolts and the lower drive has separated from the upper by about 1/4 inch, such that the dowels have disengaged but the lower unit wont come off any further.
Alpha 1 Gen 1 lower unit removal | IFish Fishing Forum
网页2014年10月9日 — All 6 bolts are removed. (1 front, 1 rear under the anode, 2 under cavitation plate, 2 bottom). The case is binding up in the front as if the front bolt isn't removed but...it obviously is removed. I'll attach a pic in a few minutes, but it's separated all the way to the middle bolts...front won't let go.